Baby Safety Gate (B6900)

Adjustable, Fits Standard Stair Ways: 100cm to 108cm (39 1/2” to 42 1/2” inches)

Can be used in:

- Staircase

- Suitable for staircase, corridor, kitchen's entrance and more...

- Easy to assemble and Unleaded Epoxy Painting Safe for Baby

Single Handed Operation with Safety Release Latch

A. The “BABY GATE" looks elegance and is safe in-use, it is also very volatile and easy to install. When not install, its looks like a”V” shape. (A)

B. First, use a pencil to mark the desire position and then fix the “Safety Cap” (C) onto the marked position and tighten by screw.

C. Once the: Safety Cap” (C) Is fixed in position, than connect the “Main Cap” (D) of the “Adjustable treaded Bar” by slotting into the “Safety Cap” (C). Turn the “Adjustable Nut” (E) gradually until the “V” shape position parallel to position (B).

D. The actual finishing of a proper fixed “BABY GATE” shall appear as shown in this picture, not in “V” shape (A) anymore.

E. The BABY GATE” is so light and easy to master, just lift the “Gate” upward by a single hand and it will open forward or/and backward. This exercise can only be done by adult as it is operated by a well designed “SAFETY RELEASE LATCH” (operated by spring) installed inside the tube. Hence, Children SAFETY is wall protected.

F. The “BABY GATE’  comes with EXTRA feature, an OPTIONAL Panel set (15cm or 6” long per set) is available to cater for various length or measurement of Staircase and Corridor. To install, remove  the whole “Adjustable Treaded Bar” (G) from the existing panel, and then connect the OPTIONAL panel set (F) by slotting in from one end to the other. Re-install the whole “Adjustable Treaded Bar” (G) again at the other end and repeat the installation process again as shown above.